化粪池模具的结构说明,外形一般为横放的圆筒状,两端封头一般采用力学性能良好的车轮状凹凸面设计,内部设有相通的隔舱板,隔舱板上一般设有立体弹性填料,用来截留更多的厌氧细菌。污水首先由进水口排到第一格,在第一格里比重较大的固体物及寄生虫卵等物沉淀下来,利用池水中的厌氧细菌开始初步的发酵分解,经第一格处理过的污水可分为三层,第三格功能主要起暂时储存沉淀已基本无害的粪液作用,最后,经过再次沉淀的粪液通过排水管流入市政管网。而新型化粪池模具比常见的多了一道发酵腐化的工序,工艺更细化,水质更干净。 Septic tank mould structure, general for horizontal cylindrical shape, good mechanical properties of commonly used head on both ends of the wheels of concave and convex surface design, it has similar bulkhead, bulkhead on general equipped with three-dimensional elastic filler, used to intercept more anaerobic bacteria. Sewage from the inlet line to the first first, in the first big in proportion of solid and parasitic ovum etc settle, primarily using anaerobic bacteria in the water began to ferment decomposition, the first case treated effluent can be divided into three layers, the third feature is a temporary storage precipitation has been largely harmless waste liquid, and finally, after again the precipitation of waste liquid by drains into the municipal pipe network. In addition, a new type of septic tank mould is more refined and cleaner than the common one. 　　随着化粪池模具行业的需求量增大,对于一些简单的模具产品,在时间上要求是很紧的,因此新型化粪池模具等产品就得到了广泛利用,这种产品不但可以加快生产进程,而且可以降低人员投入,减少人工成本,质量好而且成本低,生产速度更快。在进行生产时必须是完全脱模,产品不能有遗留在模具内,顶出行程要大于产品的高度,顶出后,产品要能自动的从模具里掉落,或者采用机械手能取出,须保证顶针板在模具闭合前先复位,因此往往需要安装先复位机构,特别是当化粪池模具内有滑块等结构的时候,需要设置复位报警装置,保证模具安全运行。 Increase with the demand for septic tank mould industry, for some simple mould products, requirements on time is very tight, so new septic tank mold and other products has been widely used, this product can not only accelerate the process of production, but also can reduce personnel investment, reduce artificial cost, good quality and low cost, production speed is faster. When making the production must be fully release, the product can't have left in the mould, the height of the ejector stroke is greater than the product, after ejection, the product will automatically fall off from the mould, or using manipulator can remove and shall ensure that thimble board before die closed reduction, so often need to be installed to reset institutions, especially when septic tank mold with sliders structures, such as need to set up reset alarm device, ensure the safe operation of the mould.